![]() While driving, be aware of these potential hazards: ![]() Note: Checklists are provided as a guide only and are not a substitute for complying with OSHA standards.Ĭhecklists for internal combustion and electric trucksĬhecklists for various truck types and sample generic checklist Sample Daily Checklists for Powered Industrial Trucks. Note: Always use personal protective equipment such as a face shield, long sleeves, and gauntlet gloves when checking liquid propane tanks and fittings. Note: Always use personal protective equipment such as a face shield, rubber apron, and rubber gloves when checking electrolyte. These include but are not limited to:Ĭables and connectors for frayed or exposed wires In addition to this general inspection, additional items should be checked depending on the forklift type (electric or internal combustion, including liquid propane). Check for grease and debris.Īll safety devices are working properly including the seat belt. Check that information on the nameplate matches the model and serial numbers and attachments. Ensure all warning decals and plates are in place and legible. Tire condition and pressure including cuts and gouges.Ĭondition of the forks, including the top clip retaining pin and heel. Use a stick or other device to check chain tension. NOTE: Operators should not place their hands inside the mast. Leaks, cracks or any other visible defect including hydraulic hoses and mast chains. Any problems should be recorded on the appropriate documents and reported to a supervisor.īefore starting your vehicle, conduct a pre-operation (or pre-start) inspection that checks a variety of items, including but not limited to:įluid levels - oil, water, and hydraulic fluid. ![]() Remember! A vehicle in need of repair, defective or in any way unsafe, should not be driven and should be taken out of service immediately. The forklift should not be placed in service if the examinations show that the vehicle may not be safe to operate. The operator should conduct a pre-start visual check with the key off and then perform an operational check with the engine running. Forklifts used on a round-the-clock basis must be examined after each shift. OSHA requires that all forklifts be examined at least daily before being placed in service.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |